This tree is on the way to my shed - It is a passing acquaintance.
It was shelf preparation time in the shed today, and I cut the particleboard to size before adding the facings. These act as cosmetic covers to the laminated board end grain - if it can be called that.
The shelves are deep, and the facings are around 50mm wide.
The facings need jointing to ensure they are completely straight and square. On short pieces like these, a number 6 sized bench plane is just about perfect. This is a Millers Falls 18C - look at those lovely shavings.
There are several methods for attaching these, but I decided to use biscuits. Dowels would work fine, and perhaps even a tongue and groove joint. Biscuits are easy and quick. The facings and the shelf are marked together so that the slots line up after cutting.
Give the assembled edge a dummy run before adding the glue and clamping up.
Then - glue, clamp, clean up and set to dry.
Carcass assembly comes next, but that might have to wait.
Tomorrow is the big day when the grandkids and I pick up the chookies - Doris, Florence, Edith, Esther and Sarah (the chooks - not the grandkids)
Family time - yippee.
That's some sweet biscuiting there Dad
ReplyDeleteSweet as a nut.
ReplyDeleteThe twins ran me ragged over the weekend - I am still in recovery mode. Back to the shed tomorrow - ee-ha!